Cement pipe equipment requires power control, whether it is the simplest
vertical pipe machine, suspension roll pipe machine, Centrifugal
Concrete Electric Pole Machine or more complicated radial extrusion and
mandrel vibration pipe making machine. In actual production, due to the need to
frequently start and stop these pipe-making equipment and related auxiliary
equipment can not delay the hind legs in the future production, it is very
important to protect the fragile power supply, how to protect the power
equipment of the cement pipe equipment, This is very worthy of your attention,
so take a few minutes to find out.

　　The service life of the Cement Tube Making Machine varies according to the user's degree of maintenance of the equipment. Timed maintenance and related operations are important ways to extend the life of the equipment. What are the maintenance areas in the whole set of cement pipe equipment? Many people will say that it is enough to maintain their bearings. Do not refute your view, bearing maintenance is necessary, but the most easily overlooked is the equipment power supply, do you know the maintenance methods of the power supply and control system? Today, I will introduce some method steps for the protection device of the power supply of cement pipe equipment.

Cement Tube Making Machine

　　First of all, I want to make the machine have a good working condition. The following four points are necessary to compare the current situation with the current situation. The best is done, and the need to do it is strengthened.

　　First, for the choice of the power cord, you should choose a relatively thick wire, usually 25mm2 aluminum wire or 16mm2 copper wire. If the line is too thin,
it will cause the cement pipe equipment to operate at low pressure. The electronic components in the entire control cabinet are overloaded. It is difficult to think about it. For the equipment, it is very harmful and more
serious. It will cause harm to personal safety and alert you.

　　Second, for the voltage requirements of the starting equipment, the high voltage is generally 380v-410v, the low voltage is controlled at 330v-360v, the power line grounding device should be done well, and the power supply equipment should have a protective cover device to protect the sun, rain, and leakage.
Protection measures.

　　Third, each equipment's power box should set up one device as a control source. This installation design is more conducive to the opening and closing of the equipment. The metal box of the distribution box and switch box and the metal case of all electrical equipment must be grounded for protection. The door of the cabinet should be intact and can be locked, and it must have protection measures against rain and dust, and there are danger signs. The unified number
of the distribution box and switch box is managed by a licensed full-time
electrician.

　　Fourth, the equipment power manager to find a professional electrician to
serve, to be familiar with the internal equipment and power connections.

　　As long as everyone pays attention to the above-mentioned precautions on
the power system in daily production, it is believed that the service life of
the power control system will be greatly improved, and the longer the equipment
is used, the longer the operator will be. It will be a cost reduction, check
your power and control system.

　　Our company Concrete Electric Pole Machine Supplier,
welcome to come to consult.

By